Jogger Fence Position - Ricoh B082 Service Manual

ADJUSTMENT

3.2.2 JOGGER FENCE POSITION

Dip Switch 3
ON
1 2 3 4 5 6 7 8
B546R552.WMF
After replacing the finisher board or if a paper alignment fault occurs, do this
adjustment.
Doing this adjustment once will affect all paper sizes.
1. Remove the upper rear cover.
2. Turn on dip switch 3-1 on the finisher board.
3. Press the following switch on the finisher board.
Using A4: Switch 1 (SW1)
Using 8 " x 11": Switch 2 (SW2)
1/2
• After pressing the switch, the upper exit unit will open and the jogger fences
will move to the A4 or 8
4. Place 10 sheets of A4/8
them until they touch the shutters.
5. Adjust the jogger fence position by pressing switch 1 or 2.
• Switch 1: Move to the front (0.35 mm/press)
• Switch 2: Move to the rear (0.35 mm/press)
6. Press switches 1 and 2 simultaneously to store the adjustment data.
• After pressing the switches, the upper exit unit will close.
7. Turn off dip switch 3-1, then turn off the copier main switch.
B546
SW1
LED 1
SW2
LED 2
Dip Switch 3
" x 11" position.
1/2
" x 11" paper between the jogger fences and push
1/2
B546R550.WMF
40
Rear
Jogger Fence
Front
Shutter
Jogger Fence
B546R553.WMF
SW2
SW1
SM