Primex XR Quick Install Manual page 4

CAUTION:
NTP Time Source Setup
1. Disconnect the transmitter power supply.
2. Set the dip switches 1 and 2, located on the back of the transmitter, to the up position.
3. Connect the network cable to the Ethernet port located on the back of the Transmitter.
4. Power up system.
a. Verify an NTP time has been received; an
b. Verify that the Time and Date are correct.
c. Verify that the Channel Number is set correctly.
At this point, installation of the XR Series Transmitter with GPS receiver or optional NTP time source is complete.
Channel Number
Preset by factory.
CAUTION:
Time Zone
Internal Antenna models: set the Time Zone dial to your system time zone using the dial Time Zone switch.
l
Set Time Source and Time Settings
Set the transmitter settings to meet your system requirements, per the settings specified below.
Primex Wireless
Be sure to write down and file the changes you make to network configuration settings. Once the default
static IP address is changed, the factory-default IP address will no longer work and you must use the new
settings to access the transmitter configuration.
The Channel Number is set according to the FCC Site License, do not attempt to change without contacting
Primex Wireless.
Turn to 4 for Atlantic Time Zone
Turn to 5 for Eastern Time Zone
Turn to 6 for Central Time Zone
Turn to 7 for Mountain Time Zone
Turn to 8 for Pacific Time Zone
Turn to 9 for Alaska Time Zone
Turn to A for Hawaii Time Zone
Turn to 0 for Greenwich Mean Time (GMT)
UK 1/2 Watt Transmitter - Internal Antenna Quick Install Guide 4