Extron electronics SW HD 4K Series User Manual page 30

X*
= Switch mode
0 = Manual
1 = Auto
X(
= Firmware version (to the second decimal place)
X1)
= Output HDCP mode
0 = (Default) Encrypt as required by input. Continuous trials for HDMI sinks, attempt for
10s on DVI sinks (then fail).
1 = Always encrypt. Continuous trials for HDMI sinks, attempt for 10s on DVI sinks (then
fail).
2 = Encrypt as required by input. Continuous trials for HDMI and DVI sinks.
3 = Always encrypt. Continuous trials for HDMI and DVI sinks.
X1!
= TMDS output format
0 = Auto (default)
1 = DVI RGB 444
2 = HDMI RGB "Full"
3 = HDMI RGB "Limited"
4 = HDMI YUV 444 "Limited"
5 = HDMI YUV 422 "Full"
X1@
= Verbose mode
0 = Clear/none
1 = Verbose mode (default)
2 = Tagged responses for queries
3 = Verbose mode and tagged responses for queries
X1#
= Video mute
0 = Video mute disabled
1 = Video mute enabled (TMDS)
2 = Video and sync mute
X1$
= Contact closure Status
0 = Stays in current channel if re-selected (default)
1 = Select 0 channel if current channel is re-selected
X1%
= Tally pin mode on channel mute
0 = Always on (default)
1 = Off when muted
2 = Blinks when muted
NOTE: Unless otherwise indicated, commands are not case-sensitive.
X1^
= 5 V output hot plug mode
0 = Auto. 5 V is enabled only when a source with 5 V is present.
1 = 5 V is always enabled (default)
SW HD 4K Series • Remote Communication and Control 22