Instructions For Use - Flex ID 1/4" 18.0-EC Operating Instructions Manual

Instructions for use

Before initial operation
 Unpack the power tool and accessories
and check that no parts are missing or
damaged.
 Attach the belt clip and bit holder with
the enclosed fastening screw.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge
the batteries fully. See "Charger/Charging
process".
Tool change
CAUTION!
Before carrying out any work on the power
tool, move the direction preselector switch (2)
to the middle position.
IW 1/2" 18.0-EC / IW 1/2" 950 18.0-EC /
IW 3/4" 18.0-EC:
 Push adapter on square drive of impact
driver.
 Insert tool in adapter.
18
IW 1/2" 18.0-EC / IW 1/2" 950 18.0-EC / ID 1/4" 18.0-EC / IW 3/4" 18.0-EC
ID 1/4" 18.0-EC:
 Pull tool lock forwards (1.) and press in
the tool all the way (2.).
 Release tool lock.
 To remove the tool, pull tool lock
backwards (3.).
Inserting/replacing the battery
 Press the charged battery into the power
tool until it clicks into place.
 To remove, press the release button (1.)
and pull out the battery (2.).
CAUTION!
Protect the battery contacts when the
battery is not being used. Loose metal parts
may short-circuit the contacts –
Explosion and fire hazard!