Using The Media Thickness Control; Controlling The Power Save Timer (Sleep Mode) - Colortrac SmartLF Ci 40E Installation & Operating Manual

4.6 Using the Media Thickness Control

When scanning thick documents it may be necessary to alter the value set in the media thickness control to improve the quality of
straight horizontal lines in the scan. To change the setting follows the steps below-
1
3
1. Press MENU to enter the Scanner Options menu. Media Thickness is the first option
2. Press ENTER to enter the Media Thickness screen
3. To allow thicker media scanning click the NEXT button (5 steps between Thin (0.06mm) and Thick (0.3mm)
4. Click ENTER to store the new thickness setting
The scanner is now ready to scan with thicker media. NOTE: The AUTO-STITCH procedure works independently of this control

4.7 Controlling the Power Save Timer (Sleep Mode)

Ci 40 is equipped with a Power Save Timer that puts the scanner into a 'sleep mode' to reduce the energy consumption of the
scanner when it is not scanning. The sleep timer cannot be turned off.
To alter the Power Save Timer (the time before the scanner enters sleep
mode) cursor over the number field then retype a new time in minutes.
The number must be between 2 and 15. Click Apply.
NOTE: During Ethernet configuration of the scanner it is recommended not
to set the value of the Power Save Timer below 15 minutes (default).
To re-awaken the scanner press the red CANCEL button on the scanner
control panel. The scanner will be ready to use within 5 seconds.
Alternatively start a scanner Colortrac software application.
PAS171
Colortrac SmartLF Ci 40 Installation and Operating Manual
2
4
P/N: P005500 Colortrac Ltd © 2009
25