Chapter 2 Preparing The Scanner And Software; Connecting The Power And Interface Cable - Colortrac SmartLF Ci 40E Installation & Operating Manual

10

CHAPTER 2 PREPARING THE SCANNER AND SOFTWARE

2.1 Connecting the power and interface cable

– Start by locating the external power supply brick that is made
up from two parts – a cable and a transformer. The mains
cable part should already be terminated with a mains
connector plug suitable for your country. If the cable is not
correct contact your supplier. Plug the opposite end of the
mains cable into the brick and then push the small round plug
into the corresponding input socket on the back of the Ci 40
scanner.
THIS INSTALLATION ASSUMES A USB2 DATA CONNECTION
–
– TAKE CARE TO CONNECT THE POWER LEAD TO THE POWER
SOCKET ON THE BACK OF THE SCANNER
– The order of connection sockets on the back of the scanner
from top to bottom is:
1. POWER SWITCH – ON/OFF
2. POWER SUPPLY SOCKET
3. USB2 CONNECTION SOCKET
4. ETHERNET CONNECTION SOCKET
– Now locate the supplied USB2 interface cable (exact design
may vary from that shown). Connect the smaller end to the
scanner. Do not connect the larger end of the USB2 cable to
the computer yet.
NOTE #1: DO NOT SUBSTITUTE THIS CABLE WITH A LONGER ONE OR
–
THE PERFORMANCE OF THE SCANNER MAY BE AFFECTED
–
NOTE#2: ALWAYS FIRST INSTALL THE SCANNER USING THE USB2
INTERFACE. IF YOU WISH TO USE THE ETHERNET CONNECTION THE
NECESSARY CONFIGURATION STEP ARE DESCRIBED FURTHER ON IN
THIS MANUAL.
Now switch on the scanner using the rocker switch on the back of
–
the scanner. The liquid crystal display (LCD) should now light up
and display the word 'Initialising'. After about 30 seconds this will
change to display the name of the scanner (Ci 40) and the
firmware level. If a document is loaded the display will change to
the word 'READY'.
Start up Windows Vista or XP Professional / XP Home on the computer that will be used with SmartLF Ci 40. Wait for
Windows to finish loading before proceeding to the next section.
See section 7.3 for more information on the minimum PC specifications
The Windows .NET Framework environment
SmartLF Ci 40 is designed for use with Windows XP (Home or Professional) with the latest Service Pack (SP)
upgrade or Microsoft Vista. For XP, Colortrac advise that the .NET Framework is also installed when using the
PAS171
The Colortrac SmartLF All-in-One software application has been created using
Microsoft .NET. This means the connected computer running Microsoft
Windows XP Home or XP Professional should be upgraded if required by
installing at least .NET Version 2.0. Microsoft Vista comes pre-loaded with
.NET 3.0.
Colortrac SmartLF Ci 40 Installation and Operating Manual
P/N: P005500 Colortrac Ltd © 2009