Page 1
Handheld GNSS Receiver GIS Data Collection...
Page 2
Handbook revision situation Revision date Revision times introduction 2012.8 Handheld GNSS Receiver GIS Data Collection V1.0...
Page 3
Use of the introduction Welcome to use SL300 series high precision mobile GIS product introduction, this manual applies to Q star series, this manual introduced how to set and use SL300 series high precision mobile GIS product. Specification of the introduction...
Related information You can find the instructions through the following methods: 1 Purchased products from the Hi-Target will with a CD, open the CD and you can find the instruction; 2 Land theofficial website of the Hi-Target, through "downloaded zone"—" product specifications "—"...
Page 5
C H A P T E R Chapter 1 Products overview This chapter introduces: ■Product introduction ■Product features ■Matters needing attention in use...
In order to improve the stability of the SL300 series high precision mobile GIS productsand use cycle, please avoidSL300 series high precision mobile GIS products exposed to extreme environments , such as: damp, high temperature, low temperature, corrosive gas or liquid, etc.
Page 7
To ensure continuous observation of the satellite and satellite signal quality, the stations should be set over the open place as far as possible, barriers are not permitted in more than 15 degree; To reduce the interference of electromagnetic wave to GNSS satellite signal ,within 200 m strong electromagnetic interference is not permitted, such as TV tower, microwave station, high voltage transmission line;...
Page 8
■battery ■data cable ■belt This chapter introduces SL300 series high precision mobile GIS products appearance, interface, battery, touch pen and data cable, etc. The front of SL300 series high precision mobile GIS products The front ofSL300 series high precision mobile GIS products...
Page 9
The microphone: built-in microphone can be used for the acquisition of voice messages. The back of SL300 series high precision mobile GIS products The back ofSL300 series high precision mobile GIS products , including the camera, battery, the belt hole, horn, etc.
Page 10
Interface SL300 series high precision mobile GIS productsinterface position is identified,its main function is charging and data transmission, installing SIM card and SD card, etc. Picture2-3 ◇ Charging interface:connect the charger for lithium battery charge ◇ USBinterface:the connection computer, used for data transmission.
Belt Because SL300 series high precision mobile GIS productis big, in order to prevent sliding in the process of working, it is equipped with antiskid belt,please entangle belt whenyou work .
. Now we will introduce the appearance and function of the keyboard simply. Keyboard keyboard. The keyboard keys contains: the SL300 series high precision mobile GIS products confirmation button , exit key, F1 function keys, switch machine key and the direction key.
◊ The battery installation and removal Install the battery, contact the battery with a metal connector on one end with SL300 series high battery jar copper point, and screw up the screw. precision mobile GIS product Take out the battery,take out the screw firstly, the battery will popup little, then you can take it out.
Page 15
The concrete use method and requirements:charging with standard configuration is demanded when charging the SL300 series high precision mobile GIS product,charge in 10 ℃ ~ 40 ℃ temperature range. Using for the first time in general, there should besome battery power, you should use up the inside electricity beforecharging again, the first three charging must achieve12 hours, after that charging 6 hours.
Page 16
Figure 3-9 ◊ shutdown On state, long press 3 seconds, it will tip you to confirm shutdown, click on the "shut down". Figure3-10 Network connection Click "start" - > "DialConnect", if you have set up dial-up parameters, click "dial-up connection",you can direct dialing.
First,switch on , enter the Windows SL300 series high precision mobile GIS product system,it is no need to open applications. Connect the USB port which with a smallercable line with , connect the other end USB plug with SL300 series high precision mobile GIS product your PC.
Technology parameters Technology parameters This chapter willintroduces yourelated parameters of SL300 series high precision mobile GIS , the product function will vary according to the different models. When you refer to this product chapter, please refer to corresponding technical parameters according to the equipment you purchase.
Page 19
Integrated microphone and speakers √ √ √ √ √ The built-in bar code scanner √ Data communication Bluetooth:bluetooth √ √ √ √ √ Interface: Mini USB interface √ √ √ √ √ Storage: Micro SD card slot, 32 G at most √...
Need help?
Do you have a question about the SL300 series and is the answer not in the manual?
Questions and answers