Getting Started; Unpacking Meisterstück; Inserting The Battery In The Remote Control - Sonoro MEISTERSTÜCK SO-610 Operating Manual

3

Getting started

3.1 Unpacking MEISTERSTÜCK
1. Take MEISTERSTÜCK out of the packaging and check whether
MEISTERSTÜCK or the individual parts exhibit damages. If this is the
case, do not use MEISTERSTÜCK. Should you detect any damage,
contact your dealer or sonoro audio GmbH customer support
immediately.
2. Check to make sure that the delivery is complete (see chapter "Scope
of delivery").
3. Place MEISTERSTÜCK at a suitable location.
4. Remove the protective film from the display.
5. Remove the protective card from the subwoofer driver.
3.2

Inserting the battery in the remote control

1. Open the battery compartment cover on the back of the remote
control by turning it anticlockwise using a small coin.
2. Insert the supplied batteries (CR2032, 3 V) with the label (+) side up.
3. Replace and close the battery compartment cover by turning the
cover clockwise using a small coin.
i
Do not block the infra-red sensor on the MEISTERSTÜCK and the
infra-red transmitter on the remote control during use.
© sonoro audio GmbH 2017 73