How To Program The Z-Wave Device - Axis T8341 User Manual

AXIS T8341 PIR Motion Sensor

How to program the Z-Wave device

How to program the Z-Wave device
Note
Programming Z-Wave devices using a Z-Wave controller is recommended for experienced users only.
Z-Wave Group
The detector supports either one of two Z-Wave Association Groups:
Group 1: Association with 1 Controller node.
Group 2: Association with 4 nodes (i.e. end devices such as smart plugs and other lighting controllers). This allows the detector to
transfer commands directly to end devices without the participation of the controller. This has the effect that when the detector
triggers, all devices associated with detector will be operated.
Note
Association-group support can vary among Z-Wave Controllers. The AXIS M5065 supports Z-Wave Association Group 1.
Group 1 commands:
• When the device is powered up and already is a part of a Z-Wave network, the unit will send a Notification Report to
the node in Group 1.
• When the detector senses a movement, the unit will send a Notification Report to the nodes of Group 1. Once the
movement is stopped, a Notification Report will be sent again to Group 1.
• When the detector's status is changed, the device will check its battery status simultaneously. If the battery level drops to
an unacceptable level, the device will emit a Battery report to the nodes of Group 1.
• When you perform a Factory Reset, the unit will send Device Reset Locally Notification to the node of Group1.
Group 2 commands:
• When the detector is triggered, the unit will send BASIC_SET command which contains a value to the nodes of Group 2.
Z-Wave Plus® ® ® info
Role type
Slave Sleeping report
Version
Protocol library
Protocol version
Manufacturer
Manufacturer ID
0x0364
AGI (Association Group Information) table
Node type Installer Icon
Z-Wave Plus node Sensor Notification Device Type
(Home Security)
Product Type
0x0002
3 (Slave_Enhance_232_Library)
4.3D ( 6.71.01)
Product ID
0x0001
7
User Icon
Sensor Notification Device Type
(Home Security)