AXIS T8341 PIR Motion Sensor
How to add a device to a Z-Wave Network
How to add a device to a Z-Wave Network
Auto inclusion
The motion sensor supports the auto inclusion feature where it will automatically enter Inclusion mode when first powered up.
This will also apply when powered up after a factory reset.
1. Use a screwdriver to detach the battery cover.
2. Put the AXIS M5065 camera (or other Z-Wave controller) into inclusion mode.
3. Insert 1 CR123 3V batteries into the battery compartment with the correct polarity. The LED on the device should turn ON
4. Enter PIN number into the Z-Wave controller. The PIN number can be found on the device. See where in the installation
guide.
5. The inclusion process should be completed when the LED stops blinking
6. Perform test before you refit the battery cover. See How to test the Z-Wave Device.
Manual inclusion
You can also choose to manually add the Z-Wave device to a control device. Please follow the steps described below.
Note
For best results, exclude the device before starting the inclusion process. For more details see the installation guide.
1. Use a screwdriver to detach the battery cover.
2. Put the AXIS M5065 camera (or other Z-Wave controller) into inclusion mode.
3. Insert 1 CR123 3V batteries into the battery compartment with the correct polarity. The LED on the device should turn ON
4. Press the tamper switch 3 times within 1.5 seconds to put the unit into learning (inclusion/exclusion) mode.
5. Enter PIN number into the Z-Wave controller. The PIN number can be found on the device. See where in the installation
guide.
6. The inclusion process should be completed when the LED stops blinking.
7. Perform test before you refit the battery cover. See How to test the Z-Wave Device.
Manual exclusion
1. Use a screwdriver to detach the battery cover.
2. Press the tamper switch 3 times within 1.5 seconds to put the unit into learning (inclusion/exclusion) mode.
3. The exclusion process should be completed when the LED stops blinking
4. Refit the battery cover.
5