Z-Wave Configuration - Axis T8341 User Manual

AXIS T8341 PIR Motion Sensor

Z-Wave configuration

Z-Wave configuration
The following information is for someone that has some experience in setting up a Z-Wave system, or someone that has computer
software running a Z-Wave controller. Please get familiar with the software of the Z-Wave controller before getting started.
To minimize power consumption of the battery, RF on the device is switched off as default. In order to start the set up process, please
press the tamper switch once to turn on the RF power for 30 seconds. You can then see the LED start to blink every second. If set up
is not finished within 30 seconds, please press the tamper switch one more time to continue the set up
• Basic set level
When a Basic Set Command is sent and contains a value, the receiver will process it. For example, a lamp module would
receive a Basic Set command which determines the dim level.
Example:
1-99: ON (Binary Switch Device)
Dim Level (Multilevel Switch Device)
Function
Basic Set level
• Sensitivity level (PIR sensor only)
For optimal efficiency, it is recommended to test the detector's response to movements from the farthest end of the
coverage area when you use it for the first time. If movements cannot be detected accurately, simply adjust the sensitivity
level with the Configuration Parameter #3. This parameter can be configured with a value from 1 to 10, where 1 means
low sensitivity and 10 means highest sensitivity.
Function
Sensitivity level
• Re-trigger interval setting (PIR sensor only)
The configuration parameter used to adjust the re-trigger interval after the detector has been triggered as configuration
parameter #4. No response will be made during this interval if a movement is detected. The time interval can be set
between 5 seconds to 3,600 seconds.
Function
Retrigger interval
• Lux level
You can set a percentage for the lux level which determines when the light sensor will be activated. If the ambient
illumination drops below the set percentage, and a person moves across or within the protected area, the detector will
emit a Z-Wave ON command (i.e. Basic Set command (Value = Basic Set Level)) to the controller and activate connected
modules and lighting. The percentage can be set between 1% to 100%.
Function
Lux level
On-off duration
The on-off duration setting can be useful if the detector is connected to a module or lighting. The duration determines how long the
module/lighting should stay ON. For instance, a Lamp Module turns off 100 secs after it has been turned on. The duration can be
configured to last between 5 to 3600 seconds.
Parameter number Size
1 1
Parameter number Size
1
3
Parameter number Size
4 2
Parameter number
Size
5 1
Range
1~99
Range
1~10
Range
5~3600(sec)
Range
1~100%
10
Default
99
Default
6
Default
180
Default
20