The device is Z-Wave® enabled and fully compatible with any Z-Wave enabled network. The device can be set up in a Z-Wave network to communicate directly with other end-devices such as lighting controllers, or to report directly to a Z-Wave controller, such as AXIS M5065 PTZ Network Camera.
1. Use a screwdriver to detach the battery cover. 2. Put the AXIS M5065 camera (or other Z-Wave controller) into inclusion mode. 3. Insert 1 CR123 3V batteries into the battery compartment, observing the correct polarity. The LED on the device should turn ON.
AXIS T8341 PIR Motion Sensor How to test the Z-Wave device How to test the Z-Wave device Warm-up It will take the motion sensor approximately 2 minutes to warm up after the battery is inserted. During this period the LED behind the lens will turn on.
This has the effect that when the device triggers, all other associated devices will also be operated. Note Association group support can vary among Z-Wave Controllers. The AXIS M5065 supports Z-Wave Association Group 1. Group 1 commands: •...
Page 8
AXIS T8341 PIR Motion Sensor How to program the Z-Wave device Group Profile Command Class & Command Group Name (UTF-8) (List) N bytes General Battery Report Lifeline Notification Report Device Reset Locally Notification Control Basic Set PIR Control Notification Event...
Page 9
AXIS T8341 PIR Motion Sensor How to program the Z-Wave device • COMMAND_CLASS_NOTIFICATION_V4 • COMMAND_CLASS_CONFIGURATION Wake-up command class After the detector has been included in a Z-Wave network it will go to sleep, but will periodically send a wake-up notification command to the controller at a preset period.
AXIS T8341 PIR Motion Sensor Z-Wave configuration Z-Wave configuration The following information is for persons with experience of setting up a Z-Wave system, or for someone that has computer software running a Z-Wave controller. Please familiarize yourself with the Z-Wave controller’s software before getting started.
Page 11
AXIS T8341 PIR Motion Sensor Z-Wave configuration Function Parameter number Size Range Default On-Off Duration 5~3600(sec)
AXIS T8341 PIR Motion Sensor Troubleshooting Troubleshooting If you can’t find what you’re looking for here, try the troubleshooting section at axis.com/support The table below explains the status in the Z-Wave controller as well as the LED indication on the device. Description...
AXIS T8341 PIR Motion Sensor Specifications Specifications To find the latest version of the product’s datasheet, go to the product page at axis.com and locate Support & Documentation. Specifications Battery CR123 3.0V Lithium Battery Battery life 1 year* Range Up to 100m (328 ft) line of sight...