Table of Contents
Advertisement
AXIS F9114 Main Unit
Get started
Get started
Connect sensor units
When you connect a sensor unit to a main unit, we recommend that you make the connection before you power up the main unit. If
you disconnect a sensor unit and connect a different one, you must restart the main unit.
Shorten the sensor unit cable
Note
• Incorrect shortening of the cable can lead to image degradation or image loss.
To shorten the cable follow these steps:
1. Cut the cable to the desired length. Measure from the sensor unit.
2. Strip the plastic outer coating from the end of the cable.
3. Put the small insulator sleeve on the inner conductor of the cable and weld or crimp the center pin on the inner wire
of the cable.
4. Put the heat-shrinkable tube and copper tube on the cable.
5. Insert the cable into the connector.
6. Push the copper tube onto the connector and then Hex. Use a crimping tool to fasten the copper tube on the connector.
7. Heat the heat-shrinkable tube.
For more information, see the Connector Kit FAKRA Installation Guide.
Find the device on the network
To find Axis devices on the network and assign them IP addresses in Windows®, use AXIS IP Utility or AXIS Device Manager. Both
applications are free and can be downloaded from axis.com/support.
For more information about how to find and assign IP addresses, go to How to assign an IP address and access your device.
Browser support
You can use the device with the following browsers:
®
Windows
®
macOS
®
Linux
Other operating systems
*To use AXIS OS web interface with iOS 15 or iPadOS 15, go to Settings
NSURLSession Websocket.
If you need more information about recommended browsers, go to AXIS OS Portal.
TM
Chrome
Firefox
recommended
recommended
recommended
recommended
recommended
recommended
®
TM
Edge
Settings > > > Safari
Settings
Safari > > > Advanced
Safari
Advanced > > > Experimental
Advanced
3
®
Safari
*
Experimental Features
Experimental
Features and disable
Features
Advertisement
Table of Contents
