Assembly - ProForm Trainer PFTL39507.1 User Manual

ASSEMBLY

To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480.
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the
top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included hex keys
adjustable wrench
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is
the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses
is the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it is preattached to one
of the parts to be assembled. Extra hardware may be included. To avoid damaging plastic parts, do not use
power tools for assembly.
M8 Star
Washer (10)–4
Washer (8)–4
Bolt Spacer (79)–4
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (48) so that the treadmill is more stable;
do not fully fold the Frame yet.
Cut the tie securing the Upright Wire (77) to the
Base (85). Locate the tie in the indicated hole in
the Base, and use the tie to pull the Upright Wire
out of the hole.
Attach a Base Pad (81) to the Base (85) in the
location shown with a Base Pad Spacer (71) and
an M4 x 25mm Screw (2). Then, attach another
Base Pad (81) with only an M4 x 25mm Screw
(2).
and your own Phillips screwdriver
.
M10 Star
M10 Nut
(33)–2
M4 x 19mm
Latch Screw (A)–2
M10 x 96mm Bolt (5)–4
M4 x 13mm
Screw (3)–1
Base Pad Spacer
(71)–2 M4 x 19mm
Screw (1)–6
1
Hole
48
71
81
2
6
M4 x 25mm
Screw (2)–4
M8 x 25mm
Bolt (6)–4
M10 x 50mm Bolt (27)–2
85
77
Tie
and
81
2