Revision A8 - Cirrus SR22 Pilot Operating Handbook

Cirrus Design
SR22
loss of attitude information until the PFD can be restarted on
the ground.
Aircraft equipped with Software Version 530-00159-000 Rev
00 or higher; When subjected to a power loss of less than 20
seconds, the PFD is capable of performing a warm start. In
this event, a "PLEASE STANDBY" message will be displayed
for 2 seconds followed by a "ATTEMPTING QUICK RESTART"
message. In the event of a power loss greater than 20
seconds, a warm start is unlikely, and the power interruption
will result in loss of attitude information until the PFD can be
restarted on the ground.
Power Lever Linkage Failure
If the Power Lever linkage fails in flight, the engine will not respond to
power lever control movements. Use power available and flaps as
required to safely land the airplane.
If the power lever is stuck at or near the full power position, proceed to
a suitable airfield. Fly a forced landing pattern. With landing assured,
shut down engine by moving mixture control full aft to CUTOFF. If
power is needed again, return mixture control to full RICH and regain
safe pattern parameters or go-around. If airspeed cannot be
controlled, shut engine down and perform the Forced Landing
checklist. After landing, bring the airplane to a stop and complete the
Emergency Engine Shutdown on Ground checklist.
If the power lever is stuck at or near the idle position and straight and
level flight cannot be maintained, establish glide to a suitable landing
surface. Fly a forced landing pattern.
1. Power Lever Movement...................................................... VERIFY
2. Power .............................................................................SET if able
3. Flaps ........................................................................ SET if needed
4. Mixture ..................................... AS REQUIRED (full rich to cut-off)
5. Land as soon as possible.
P/N 13772-001
Revision A7
Section 3
Emergency Procedures
3-27