Revision A5 - Cirrus SR22 Pilot Operating Handbook

Section 4
Normal Procedures
7. Right Wing Forward and Main Gear
a. Leading Edge and Stall Strips ...................................Condition
b. Fuel Cap ....................................... Check Quantity and Secure
c. Fuel Drains (2 underside) ............................ Drain and Sample
d. Wheel Fairings...................... Security, Accumulation of Debris
e. Tire ............................................Condition, Inflation, and Wear
Serials 0002 through 1727 after Service Bulletin SB 2X-32-14
and airplane serials 1728 and subsequent: Clean and inspect
temperature indicator installed to piston housing. If indicator
center is black, the brake assembly has been overheated. The
brake linings must be inspected and O-rings replaced.
f. Wheel and Brakes ....... Fluid Leaks, Evidence of Overheating,
General Condition, and Security.
g. Chocks and Tiedown Ropes........................................Remove
h. Cabin Air Vent..................................................... Unobstructed
8. Nose, Right Side
a. Vortex Generator .......................................................Condition
b. Cowling .................................................... Attachments Secure
c. Exhaust Pipe ....................Condition, Security, and Clearance
d. Transponder Antenna (underside) .. Condition and Attachment
e. Gascolator (underside) ................Drain for 3 seconds, Sample
9. Nose gear, Propeller, and Spinner
Keep clear of propeller rotation plane. Do not allow others to
approach propeller.
a. Tow Bar........................................................Remove and Stow
b. Strut ...........................................................................Condition
c. Wheel Fairing........................ Security, Accumulation of Debris
d. Wheel and Tire ..........................Condition, Inflation, and Wear
4-8
• Caution •
• WARNING •
Cirrus Design
SR22
P/N 13772-001
Revision A8