Aileron System - Cirrus SR22 Pilot Operating Handbook

Hide thumbs Also See for SR22:

Table of Contents

Cirrus Design

Airplane Description

Aileron System

The ailerons provide airplane roll control. The ailerons are of

conventional design with skin, spar and ribs manufactured of

aluminum. Each aileron is attached to the wing shear web at two hinge

Aileron control motion is generated through the pilot's control yokes by

rotating the yokes in pivoting bearing carriages. Push rods link the

pivoting carriages to a centrally located pulley sector. A single cable

system runs from the sector to beneath the cabin floor and aft of the

rear spar. From there, the cables are routed in each wing to a vertical

sector/crank arm that rotates the aileron through a right angle conical

P/N 13772-001

Table of Contents