Table of Contents
Advertisement
6.
Replace the drive. After swapping the drive, fasten the retention screws. Refer
to the screw locations in the previous step.
7.
Insert the drive tray back into the enclosure. Install the drive tray with the front
bezel open. When fully inserted, close the front bezel.
8.
Lock the drive tray. Turn the bezel lock vertical (locked position) using a flat
blade screwdriver. Do not push the bezel lock while turning it, otherwise the
spring handle will pop out again.
Note!
Never leave the bezel lock unlocked – the RAID controller may consider
it a faulty drive.
9.
Check for drive errors. Ensure that no further errors are reported.
93
ASR-5300I Series Hardware User Manual
Advertisement
Table of Contents
