Advantech ASR-5300I Series User Manual page 102

4. Remove the drive tray. Pull the tray one inch from the enclosure. Wait at least 30
seconds for the disk drive to spin down, and then gently withdraw the drive tray
from the chassis.
5. Remove the four retention screws (two on each side). The screws secure the
hard drive to the drive tray.
2.5" SAS HDD (without MUX)
2.5" SATA HDD (with MUX)
MUX board screw locations
ASR-5300I Series Hardware User Manual
3.5-inch tray 2.5-inch tray
2.5-inch SAS hard drive
2.5-inch SATA hard drive
92