Engine Oil And Oil Filter Change - Triumph Tiger 1200 XR 2017 Owner's Handbook Manual

Maintenance
Note:
• An accurate indication of the level
of oil in the engine is only shown
when the engine is at normal
operating temperature
motorcycle is upright (not on the
side/centre stand).
• Start the engine and run at idle for
approximately five minutes.
• Stop the engine, then wait for at
least three minutes for the engine
oil to settle.
• Note the engine oil level visible in
the sight glass.
• When correct, engine oil should be
visible in the sight glass at a point
halfway between
(maximum) and lower (minimum)
horizontal lines marked on the
crankcase.
• If necessary, top up the engine oil
level as described earlier.
• Once the correct level is reached, fit
and tighten the filler plug.

Engine Oil and Oil Filter Change

Warning
Prolonged or repeated contact with
engine oil can lead to skin dryness,
irritation and dermatitis.
In addition, used engine oil contains
harmful contamination that can lead to
skin cancer.
Always wear
clothing and avoid skin contact with
used engine oil.
176
and
the upper
suitable protective
The engine oil and filter must be
replaced in accordance with scheduled
maintenance requirements.
the
chgy_1
1. Engine oil drain plug
2. Oil filter
To change the engine oil and oil filter:
• Warm up the engine thoroughly,
and then stop the engine and
secure the motorcycle in an upright
position on level ground.
• Place an oil drain pan beneath the
engine.
• Remove the engine oil drain plug.
2
1