Brake Light; Steering/Wheel Bearings; Steering Inspection - Triumph Tiger 1200 XR 2017 Owner's Handbook Manual

Maintenance
To adjust the rear brake fluid level:
• Release the screws and remove the
heel guard.
• Release the reservoir cover screws,
then remove the reservoir and the
diaphragm seal.
• Fill the reservoir to the upper level
line using new DOT 4 fluid from a
sealed container.
• Refit the reservoir cover making
sure that the diaphragm seal is
correctly positioned between the
reservoir cover and reservoir body.
• Tighten the reservoir cover screws
to 1.5 Nm.
• Refit the heel guard and tighten its
screws to 7 Nm.

Brake Light

Warning
Riding the motorcycle with defective
brake lights is illegal and dangerous.
An accident causing injury to the rider
and other road users may result from
use of a motorcycle with defective
brake lights.
The brake light
independently by either the front or
rear brake. If, with the ignition in the ON
position, the brake light does not work
when the front brake lever is pulled or
the rear brake pedal is pressed, have
your authorised
investigate and rectify the fault.
188
is activated
Triumph dealer

Steering/Wheel Bearings

Caution
To prevent risk of injury from the
motorcycle falling
inspection, make
motorcycle is stabilised and secured on
a suitable support.
Do not exert extreme force against
each wheel or
vigorously as this may cause the
motorcycle to become unstable and
cause injury by falling from its support.
Make sure that the position of the
support block will not cause damage to
the sump.

Steering Inspection

Lubricate and inspect the condition of
the steering (headstock) bearings in
accordance
maintenance requirements.
Note:
• Always inspect the wheel bearings
at the same time as the steering
bearings.
during the
sure that the
rock each wheel
with scheduled