Table of Contents
Advertisement
Caution
Covering the headlight lens during
operation
with
luggage,
adhesive
intended
to
alter
headlight
beam
headlight lens covers will cause the
headlight lens to overheat and distort,
causing irreparable damage to the
headlight assembly.
Damage caused by overheating is not
considered a manufacturing defect
and
will
not
warranty.
If the headlight must be covered
during use – such as taping of the
headlight lens required during closed-
course conditions – the headlight must
be disconnected.
All Models except Tiger 1200 XR
Caution
If a fault occurs with the headlight
unit, then a message will be shown in
the
instrument
headlights will only be available in the
dipped beam mode.
Contact an authorised Triumph dealer
as soon as possible to have the fault
checked and rectified.
Continued
items
of
clothing,
tape,
devices
or
adjust
or
non
genuine
be
covered
under
display
and
Daytime Running Light (DRL) (if
fitted)
The Daytime Running Light (DRL) is
situated within the headlight assembly
and is a sealed, maintenance-free LED
unit.
The
the
replaced in the event of the failure of
the DRL.
Bend Lighting (if fitted)
Bend lighting provides additional LED
lighting for left and right turns when
riding the motorcycle. It compensates
for the bank angle of the motorcycle
when cornering in dip beam mode.
The bend lights are switched on and off
automatically as the motorcycle leans
through corners. The left hand and
right hand bend light comprises of four
separate lights which switch on and
increase in brightness depending on the
lean angle of the motorcycle. When the
motorcycle is stationary, no bend lights
are on.
the
Maintenance
headlight
unit
must
be
209
Advertisement
Chapters
Table of Contents
