PHYSICAL DESCRIPTION DC Iris DC Iris Lens Control Port Analog Video Output The IP CCD D/N PoE Box Camera supports one channel analog video output. Ethernet Port The IP CCD D/N PoE Box Camera connects to the Ethernet via a standard RJ45 connector.
Page 6
Step 2: Press and continue to hold the Reset Button with a pointed object. Reconnect the power cable while still holding the reset button. Step 3: Keep the reset button depressed for at least 6 seconds before releasing it. The unit will then start up with factory default settings.
Page 7
transient voltages. The I/O terminal pins are numbered left to right, as shown below. Connect input/output devices to the camera as follows: 1. Attach the cables for the device securely to the supplied green connector block. 2. Once the cables are connected, push the connector block into the terminal connector (also green) on the camera.
BASIC CONNECTIONS Follow the procedures below to connect the IP device to the respective apparatuses. 1. Connect an analog monitor to IP device video out (BNC Connector) 2. Connect the power adaptor to IP device 3. Connect IP CCD D/N PoE Box Camera’s ethernet port to an Ethernet (RJ45 connectors).
Quick Tour This section guides you with a quick tour on this IP device. 2.1 Configure this IP Device 2.1.1 Make sure network environment Default IP of this IP device is 192.168.0.100. Please make sure this IP device and your PC are on the same network segment before running the installation. Please set the settings as below.
Page 11
2.1.2 Open Internal Explorer with IP address NOTE: Internet Explorer 6.0 or above is highly recommended. You may download it from http://www.microsoft.com/windows/ie/downloads/default.mspx The default IP address for this device is 192.168.0.100 2.1.3 Login with default administrator’s account & password NOTE: Default administrator account is set to Admin, password is set to 123456, and click button.
Page 12
2.1.4 Preview the video 2.1.5 Set the new IP address...
Page 13
*IP Address : The default IP address is 192.168.0.100. *Subnet Mask : The default subnet mask is 255.255.255.0 *Click button NOTE: In your Client PC, please make sure the setting of Network Connections Type is set to Auto Negotation to enable best network speed performance.
Page 14
NOTE: Please make sure the TV Input (NTSC / PAL) meets your requirement , and click button. 2.1.7 Click Save Reboot to save all settings and please wait about 30 seconds for system reboot.