Related Manuals for Candy P 604/1
Summary of Contents for Candy P 604/1
- Page 1 INSTRUCTIONS FOR THE INSTALLATION AND OPERATION OF THE ELECTRIC HOB P 604/1...
- Page 2 CONTENTS Unpacking the appliance ............... 3 Recommendations ................3 • INSTALLATION Safety instructions ................. 4 Electrical connection ................. 4 / 6 Fitting the hob ..................7 • USING THE APPLIANCE Hob features ..................8 Technical data ..................8 The hot plate ..................9 Using the hot plate ................
-
Page 3: Unpacking The Appliance
UNPACKING THE APPLIANCE Inside the appliance you will find a plastic bag containing the fixing brackets required for installing the hob in the worktop. RECOMMENDATIONS TO GET THE BEST FROM YOUR APPLIANCE, PLEASE READ THE FOLLOWING CAREFULLY. Please keep the operating and installation instructions in a safe place for future reference. Before fixing the hob, note the serial number of the appliance just in case you should require repairs from our after sales service organisation at some time in the future. -
Page 4: Electrical Connection
• Any queries regarding the power supply cord should be referred to After Sales Service or a qualified technician. The hob "P 604/1" is supplied with a terminal block which enables you to choose the correct connection for the particular power supply. - Page 5 To proceed to the new connection, you must adhere to the following instructions. • Before making the connection, make sure that the installation is protected by a suitable fuse, see table on next page, and that it is fitted with wires of a large enough section to supply the appliance normally.
-
Page 6: Electrical Connection
INSTALLATION: "ELECTRICAL CONNECTION" l a r l a r 1 2 3 4 5 1 2 3 4 5 1 2 3 4 5 1 2 3 4 5 1 2 3 4 5 PH PH PH PH PH PH PH 1st phase 1st phase 1st phase 1-2... - Page 7 INSTALLATION Both the worktop where the hob will be fitted and any adjacent kitchen furniture must be made from heat resistant material and fixed with heat resistant adhesive. If, when installing the hob, the lower hob face is adjacent to an area normally accessible when handling or cleaning, fit a heatproof partition 1 cm below the base of the hob, with a 10 x 10 cm opening in the rear right-hand corner, to avoid any risk of scorching or damage.
-
Page 8: Hob Features
Building-in dimensions (cm) - (see chapter "Installation") : Width : 56 Depth : 48 Total electrical power : 7 kW In order to improve the quality of the products, CANDY may carry out modifications linked to technical improvements. Appliance meeting with the standard CEE 89/336, and 73/23. -
Page 9: The Hot Plate
THE HOT PLATE THE RAPID SELF-PROTECTING ELECTRIC HOT PLATE This is a cast-iron hot plate, controlled by a 7 position switch. Each position corresponds to a permanent and progressive temperature according to the marks 1, 2, 3, 4, 5 and 6. An internal thermostat cuts off of the power supply if overheating occurs. - Page 10 Hot plate power levels vary according to the size and the control knob setting. 0 0 0 0 0 1 1 1 1 1 2 2 2 2 2 3 3 3 3 3 4 4 4 4 4 5 5 5 5 5 6 6 6 6 6 Ø...
-
Page 11: General Maintenance 1
MAINTENANCE Before cleaning or removing the hob, it is imperative to : . disconnect the hob from the mains supply. . let all parts of the hob cool down. Never use : . harsh abrasives, scouring pads or sharp object to clean the hob. •... - Page 12 CANDY ELETTRODOMESTICI S.R.L. BRUGHERIO (MILANO) ITALIA...