Table of Contents
Advertisement
Both the worktop where the hob will be fitted and any adjacent kitchen furniture must be
made from heat resistant material and fixed with heat resistant adhesive.
If, when installing the hob, the lower hob face is adjacent to an area normally accessible when
handling or cleaning, fit a heatproof partition 1 cm below the base of the hob, with a
10 x 10 cm opening in the rear right-hand corner, to avoid any risk of scorching or damage.
There should also be a 5 cm gap between the appliance and all adjacent vertical surfaces.
A foam adhesive seal is supplied with the hob. Stick this seal under the edge of the body as
near as possible to the outer edge of the hob. Press round the edges of the hob, so that the
seal flattens out and ensures an air tight seal.
Fitting the seal
Top view of the hob
The body of the hob is fitted with 4 location holes to take the fixing brackets that secure
the intended to fix the hob in the unit. Place the 4 fixing brackets in such a way that the
hob surface is placed perfectly in the support unit.
Location for fixing brackets
INSTALLATION
SEAL
Fixing
bracket
Building-in according to TYPE Y
(Norm EN 335-2-6)
Opening 10 X 10 cm
560 mm
7
Advertisement
Table of Contents
