Candy P 604/1 Instructions For The Installation And Use page 5

To proceed to the new connection, you must adhere to the following
• Before making the connection, make sure that the installation is protected by a suitable
fuse, see table on next page, and that it is fitted with wires of a large enough section to
supply the appliance normally.
1 - Operations to be carried out in order to make a connection :
. Choose the supply cord in accordance with the recommendations in the table on the
next page.
. Turn the hob against the worktop.
. Unscrew the cover (Fig.1).
Fig. 1
. Pass the supply cord into the cable clamp (Fig. 2).
. Unscrew the shunt bars fixed on the earth terminal.
. Strip the end of each conductor of the supply cord to a 10 mm length, by taking into
account the required length of the cord for the connection on the terminal block.
. According to the installation and with the help of shunt bars, fix the conductor as
shown on the chart.
. Engage the earth wire yellow/green on the earth terminal, tighten the nut and verify
the continuity of the earth.
. Secure the cable clamp.
. Fix the cover.
Cable
Earth
clamp
Terminal
Fig. 2
instructions.
Terminal
block
5