Downloading Software - Huawei iSiteC BTS3601C Installation Manual

Installation Manual
iSiteC BTS3601C CDMA Base Station
&
Note:
1) The four angles of the chip correspond to those of the socket one by one. Make sure there is no
mistake when replacing the chip. Otherwise, the chip may be burned.
2) The chips should be replaced by authorized Huawei engineers.

3.3 Downloading Software

The boot software of BTS3601C system is installed and upgraded by replacing the
memory chip, while common board software (including CPU software and FPGA logic)
are installed and updated by downloading the software.
3.3.1 Methods of Software Loading
BTS software loading can be conducted through remote/local maintenance console.
The remote maintenance console is connected to BSC via LAN. Through IP Over
ATM (IPOA) link of BSC, it is connected to MBPM of BTS3601C, and through MBPM,
it is connected to Micro-bts Transceiver Module (MTRM).
The local maintenance console is connected to MBPM (via the Ethernet port in
MBPM maintenance window) through the crossover network cable. Through MBPM, it
is then connected to MTRM.
The connection between BTS remote maintenance console and local maintenance
console is shown in Figure 3-1.
(1) BTS3601C remote maintenance console
Figure 3-1 Connection of BTS3601C maintenance consoles
BAM
BSC
(1)
Software Installation & System Commissioning
Abis
BTS3601C
MBPM
(2)
(2) BTS3601C local maintenance console
3-2
0错 误 表 格 结 果 无 效
MTRM