Inline Power Status Messages - Cisco Aironet 1240AG Series Hardware Installation Manual

Low Power Condition
Table 6-2 Using Cisco IOS Commands
Power Source
2
Power injector used with a Cisco switch that
does not support Intelligent Power
1
Management
Power injector used with a non-Cisco switch
802.3af compliant non-Cisco switches
1. You should check the release notes for your Cisco power source to determine which Cisco IOS release supports Intelligent Power Management. Support
for Intelligent Power Management might not be currently available for your Cisco power source.
2. Power injector must be AIR-PWRINJ3 or AIR-PWRINJ-FIB.
3. Cisco switches that support Intelligent Power Management always configure the use of a power injector at the switch.
Issuing the Cisco IOS Command Using the CLI
Follow these steps to issue the Cisco IOS command for your power scenario:
Connect a PC to the access point console port and use a terminal emulator to establish a session with the
Step 1
access point (refer to the
From the privileged EXEC mode (refer to the
Step 2
the command below that applies to your power configuration (see
•
•
Enter the write memory command to save the setting to the access point memory.
Step 3
Step 4 Enter the quit command to exit the terminal session.
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
6-10
D r a f t 1 A - C I S C O C O N F I D E N T I A L
Access Point
no power inline negotiation prestandard source
power inline negotiation injector xxxx.xxxx.xxxx
(where xxxx.xxxx.xxxx is the MAC address of the
switch port to which the access point is connected)
Note
None required
None required
"Connecting to the Access Point Locally" section on page
power inline negotiation injector xxxx.xxxx.xxxx
(where xxxx.xxxx.xxxx is the MAC address of the switch port to which the access point is
connected)
The MAC address might be available from the Inline Power Status message.
Note
power inline negotiation prestandard source
Cisco IOS Commands
The MAC address might be available from the
Inline Power Status message.
"Cisco IOS Command Modes" section on page
Chapter 6 Troubleshooting
Cisco Switch
power inline never
–
–
3-4).
Table 6-2):
5-2), enter
OL-7293-01