Cisco Aironet 1240AG Series Hardware Installation Manual page 38

Mounting Above a Suspended Ceiling
The bracket mounting clip requires the use of an access point mounting plate (700-13520-03) with two
extra holes (see
Figure 2-6
1 Extra holes
Follow these steps to mount the access point above a suspended ceiling.
Insert the bracket mounting clip's tab into the large hole on the access point mounting plate.
Step 1
Place the clip over the T-bar box hanger and secure it to the access point mounting plate (see
Step 2
with the 1/4-20 fastener (supplied with the T-bar hanger).
Figure 2-7
Note
Determine the location in the ceiling where you will mount the access point and remove an adjacent
Step 3
ceiling tile.
Orient the access point 2-GHz and 5-GHz antennas so that they are pointing down when mounted on the
Step 4
T-bar Box hanger.
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
2-10
D r a f t 1 A - C I S C O C O N F I D E N T I A L
Figure 2-6).
Mounting Plate Holes
1
Access Point Mounting Plate
The illustration shows the access point mounting plate mounted perpendicular to the T-bar box
hanger. You can also mount the bracket parallel to the T-bar box hanger.
----- TBD -----
1
---- TBD -----
Chapter 2 Installing the Access Point
Figure
OL-7293-01
2-7)