Tools – Menu "Tools - MVC-Data GC630 User Manual

AccessZone® - PcManagement™ User Manual
4.10 Tools – Menu "Tools"
The tools menu contains two tools "Firmware Upload" and "Replace Gate Controller".
4.10.1 Firmware Upload Tool - Menu "Tools"-> "Firmware Upload"
The "Firmware Upload" tool can be started from PcManagement™ or directly from the Windows
installation menu "Programs". The tool can upload new firmware to the connected
GateControllers. Refer to the "Firmware Upload User Manaul".
Note!
PcManagement™ must be closed to release the used COM ports. The system will automatically
start a dialog:
4.10.2 Replace GateController Tool - Menu "Tools"-> "Replace Gate Controller"
The "Replace Gate Controller" tool makes it easy to exchange a GateController™. I.e. all the
settings and profiles are copied to the new GateController™ and the old GateController™ can be
deleted.
"Select Gate Controller to be replaced" select an existing GateController™ from the drop
down list
"Enter Controller ID for new Gate Controller" enter the ID of the new GateController™. The
GateController™ ID must not existing in the system
TIP!
The GateController™ ID can be found by connecting the system to PcManagement™.
Add the COM port number if not used before. Refer to section 4.7.1 General Settings - Menu
"Settings"-> "Program Settings" – "General". The system will automatically detect it as a new
GateController™ and add it to the system. Refer to section 4.8.4 System Info - Menu "Info" for how
to read the ID.
Delete the GateController™ again to allow settings to be copied.
The new GateController™ can be connected to the system when the settings have been copied.
All information is subject to change without notice. All other products and brand names are registered trademarks of their respective companies
Copyright © 2005-2014 All rights reserved MVC-Data ApS Skalhuse 5 9240 Nibe Denmark Web www.mvc-data.com E-mail info@mvc-data.com Phone +45 25 12 84 02
2014-03-13 US 0.17
43/47