Adjusting The Rear Wheel Toe-In - Toro Groundsmaster 4300-D Operator's Manual

6. Stop the engine. Remove the jack stands and
lower the machine to the shop floor.
7. Test drive the machine to make sure it does not
creep.
Adjusting the Rear Wheel
Toe-in
1. Rotate the steering wheel so that the rear
wheels are straight ahead.
2. Loosen the jam nut on each end of the tie rod
(Figure 64).
Note:
The end of the tie rod with the external
groove is a left hand thread.
Figure 64
1. Jam nut
2. Tie rod
3. Using the wrench slot, rotate the tie rod
4. Measure the distance at the front and rear of the
rear wheels at axle height. The distance at the
front of the rear wheels should be less than 6
mm (1/4 inch) of the distance measured at the
rear of the wheels.
5. Repeat procedure as required.
g004136
3. Wrench slot
Cooling System
Maintenance
Removing Debris from the
Cooling System
Remove debris from the screen and radiator/oil cooler
daily (clean more frequently in dirty conditions).
1. Turn the engine off and remove the key from the
ignition switch.
2. Thoroughly clean all debris out of the engine
area.
3. Unlatch the clamp and pivot open the rear
screen (Figure
1. Rear screen latch
4. Thoroughly clean both sides of the and the
radiator/oil cooler
air.
46
65).
Figure 65
2. Rear screen
(Figure 66) with compressed
g004138