Fuses - Toro Groundsmaster 4300-D Operator's Manual

Fuses

There are 8 fuses in the electrical system. The fuse
block (Figure 61) is located behind the control arm
access panel.
Figure 61
1. Fuse block
Figure 62
Drive System
Maintenance
Adjusting the Traction
Drive for Neutral
The machine must not creep when the traction pedal
is released. If it does creep, adjust as follows:
1. Park the machine on a level surface, stop the
engine, and lower the cutting decks to the floor.
2. Jack up the machine until all the tires are off
the shop floor. Support the machine with jack
stands to prevent it from falling accidentally.
3. On the right side of the hydrostat, loosen the
locknut on the traction adjustment cam
63).
g021219
1. Locknut
decal117-0169
WARNING
The engine must be running so the final
adjustment of the traction adjustment
cam can be performed. This could cause
personal injury.
Keep hands, feet, face, and other body
parts away from the muffler, other hot
parts of the engine, and any rotating
parts.
4. Start the engine and rotate the cam hex in either
direction until the wheels cease rotation.
5. Tighten the locknut to secure the adjustment.
45
Figure 63
2. Traction adjustment cam
(Figure
g004147