Product Overview - Toro Groundsmaster 4300-D Operator's Manual

Product Overview

Controls
Seat Adjusting Knobs
The seat adjusting lever
adjust the seat fore and aft. The weight adjusting
knob adjusts the seat for the operator's weight. The
weight gauge indicates when the seat is adjusted to
the weight of the operator. The height adjusting knob
adjusts the seat for the operator's height.
1. Weight gauge
2. Weight adjusting knob
Traction Pedal
The traction pedal (Figure
reverse operation. Press the top of the pedal to move
forward and the bottom to move rearward. Ground
speed depends on how far you press the pedal. For
no load, maximum ground speed, fully press the pedal
while the throttle is in the Fast position.
To stop, reduce foot pressure on the traction pedal
and allow it to return to the center position.
Mow Speed Limiter
When the mow speed limiter
will control the mow speed and allow the cutting decks
to be engaged. Each spacer adjusts the mowing
speed by ½ mile per hour. The more spacers you
have, on the top of the bolt the slower you will go. For
transport, flip back the mow speed limiter and you will
have maximum transport speed.
(Figure 4) allows you to
Figure 4
3. Height adjusting knob
4. Adjusting lever (fore and
aft)
5) controls the forward and
(Figure 5) is flipped up it
Parking Brake
To engage the parking brake,
on the brake pedal and press the top forward to latch.
To release the parking brake, press the brake pedal
until the parking brake latch retracts.
1. Traction pedal
g003954
2. Mow speed limiter
3. Spacers
Brake Pedal
Press the brake pedal
Tilt Steering Pedal
To tilt the steering wheel towards you, press the foot
pedal (Figure 5) down, and pull the steering tower
toward you to the most comfortable position and then
release the pedal.
Engine Speed Switch
The engine speed switch
to change the engine speed. By momentarily tapping
the switch, the engine speed can be increased or
decreased in 100 rpm increments. By holding the
switch down the engine will automatically move to
High or Low idle, depending on which end of the
switch is depressed.
13
(Figure 5) push down
Figure 5
4. Brake pedal
5. Parking brake
6. Tilt steering pedal
(Figure 5) to stop the machine.
(Figure 6) has two modes
g003955