Toro Groundsmaster 4300-D Operator's Manual page 17

Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast
Protected Menus
Counterbalance
Auto Idle
* Only "operator-faced" text is translated. Faults,
Service, and Diagnostics screens are "service-faced".
Titles will be in the selected language, but menu items
are in English.
About
Menu Item
Model
SN
Machine Controller Revision
InfoCenter Revision
CAN Bus
Protected Menus
There are 2 operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter:
auto idle time delay and counterbalance. These
settings can be locked by using the Protected Menu.
Note:
At the time of delivery, the initial password
code is programmed by your distributor.
Description
Controls the units used on the
InfoCenter. The menu choices
are English or Metric
Controls the language used
on the InfoCenter*.
Controls the brightness of the
LCD display.
Controls the contrast of the
LCD display.
Allows a person authorized
by your company with the
PIN code to access protected
menus.
Controls the amount of
counterbalance applied to the
cutting decks.
Controls the amount of time
allowed before returning the
engine to low idle when the
machine is stationary.
Description
Lists the model number of the
machine.
Lists the serial number of the
machine.
Lists the software revision of
the master controller.
Lists the software revision of
the InfoCenter.
Lists the machine
communication bus status.
Accessing Protected Menus
Note:
The factory default PIN code for you machine
is either 0000 or 1234.
If you changed the PIN code and forgot the
code, contact your Authorized Toro Distributor for
assistance.
1. From the M
AIN
scroll down to the S
right button (Figure
2. In the S
ETTINGS
scroll down to the P
the right button
3. To enter the PIN code, press the center button
until the correct first digit appears, then press
the right button to move on to the next digit
(Figure 11B and
until the last digit is entered and press the right
button once more.
17
M , use the center button to
ENU
M and press the
ETTINGS ENU
10).
Figure 10
M , use the center button to
ENU
M and press
ROTECTED ENU
(Figure 11A).
Figure 11
Figure 11C). Repeat this step
g028523
g028522