Toro Groundsmaster 4300-D Operator's Manual page 16

InfoCenter Icon Description (cont'd.)
Symbols are often
combined to form
sentences. Some
examples are shown
below
Using the Menus
To access the InfoCenter menu system, press the
menu access button while at the main screen. This
Engine
Key switch
Cutting units are lowering
Cutting units are raising
PIN code
CAN bus
InfoCenter
Bad or failed
Bulb
Output of TEC controller or control
wire in harness
Switch
Release the switch
Change to indicated state
Put the machine into neutral
Engine start is denied
Engine shutdown
Engine coolant is too hot
DPF ash accumulation notification.
Refer to Diesel Particulate Filter
Regeneration (page 23) for details.
Sit down or engage the parking brake
will bring you to the main menu. Refer to the following
tables for a synopsis of the options available from
the menus:
Main Menu
Menu Item
Faults
Service
Diagnostics
Settings
About
Service
Menu Item
Hours
Counts
Diagnostics
Menu Item
Cutting Units
Hi/Low Range
PTO
Engine Run
16
Description
The Faults menu contains a list
of the recent machine faults.
Refer to the Service Manual
or your Toro Distributor for
more information on the Faults
menu and the information
contained there.
The Service menu contains
information on the machine
such as hours of use, counters,
and other similar numbers.
The Diagnostics menu
displays the state of each
machine switch, sensor, and
control output. You can use
this to troubleshoot certain
issues as it will quickly tell you
which machine controls are on
and which are off.
The Settings menu allows
you to customize and modify
configuration variables on the
InfoCenter display.
The About menu lists the
model number, serial number,
and software version of your
machine.
Description
Lists the total number of hours
that the machine, engine and
PTO have been on, as well
as the number of hours the
machine has been transported
and service due.
Lists numerous counts the
machine has experienced.
Description
Indicates the inputs, qualifiers,
and outputs for raising and
lowering the cutting units.
Indicates the inputs, qualifiers,
and outputs for driving in
transport mode.
Indicates the inputs, qualifiers,
and outputs for enabling the
PTO circuit.
Indicates the inputs, qualifiers,
and outputs for starting the
engine.