Geo-Fence - REWIRE SECURITY TK102-NANO User Manual

5.15 Geo-fence

This feature allows you to create safety zones. When the TK102-NANO enters or leaves this
zone, it will send geo-fence alarm warnings to authorized numbers.
To be able to configure geo-fence TK102-NANO has to stay stationary for 5 minutes. After 5
minutes proceed as follows;
Command: stockade+password+space+latitude,longitude; latitude,longitude
In case of breach, it will respond with SMS "stockade!+location" to authorized phone
numbers every 3 minutes.
Note: The first latitude&longitude is coordinate of the top left corner of the Geo-fence, while
the second latitude&longitude is the coordinate of the bottom right corner. e.g.
stockade123456 51.460959,-2.622643;51.456842,-2.604446
You can obtain coordinates of any location from google maps by right clicking to the
desired location and selecting "what's here?" To cancel:
Command: nostockade+password e.g.
nostockade123456
5.16 Movement alarm
To be able to activate movement alert TK102-NANO has to stay stationary for 5 minutes. After
5 minutes proceed as follows;
Command:
Response: move OK e.g. move123456 0200
This will activate the movement alert with an area radius of 200 meters. Maximum radius limit
is 999 meters. In case of such a movement, it will reply SMS "Move+ latitude & longitude" to
the authorized numbers in 3 minutes intervals.
Note: Setting the radius less than 100 meters may result in false movement alerts. The fault
alert occurs if GPS position is miscalculated due to bad GPS reception. Inaccurate GPS
reading will cause the TK102-NANO to think that it is in a different location, possibly farther
from its current location, thus the processor will accept this as a movement and trigger the
movement alarm.
move+password+space+0200
11