Table of Contents
Advertisement
Quick Links
TK102-NANO
DETAILED USER GUIDE
VERSION 4.9
U
Thank you for purchasing TK102-NANO. Please read this manual carefully before using this product. Please
note that product specifications and information in this user guide are subject to changes without prior notice.
Any changes will be integrated in the latest release. The manufacturer assumes no responsibility for any errors
or omissions in this document.
Advertisement
Table of Contents
Related Manuals for REWIRE SECURITY TK102-NANO
Summary of Contents for REWIRE SECURITY TK102-NANO
- Page 1 DETAILED USER GUIDE VERSION 4.9 Thank you for purchasing TK102-NANO. Please read this manual carefully before using this product. Please note that product specifications and information in this user guide are subject to changes without prior notice. Any changes will be integrated in the latest release. The manufacturer assumes no responsibility for any errors...
- Page 2 Content Summary................................2 2 Applications................................2 3 Hardware Description............................3 4 Specs..................................4 5 Usage..................................5 5.1 SIM card installation............................5 5.2 Battery and Charger............................5 5.3 Startup................................6 5.4 Changing your password..........................6 5.5 Authorization..............................7 5.6 Simple SMS text message locating........................7 5.7 Interval Tracking..............................8 5.8 Exact street address by SMS..........................8 5.9 Cell-ID Locating (LBS)............................8 5.10 Monitor mode (Voice Surveillance).........................9 5.11 Data logging..............................9...
-
Page 3: Summary 2
1. Summary TK102-NANO can locate any remote target by using Geographic Locating System and send instant SMS or Internet reports to the user by using GSM and GPRS network. 2 Applications Vehicle rental, Fleet management etc Bike & Motorbike tracking. - Page 4 3.3 Bottom 3.4 Front 3.5 Interior...
-
Page 5: Spec.
4 Specs. Specs. Content 64mm x 46mm x 17mm ( 1.8” x 2.5” x 0.65” ) Dimensions Weight Network GSM/GPRS Band 850/900/1800/1900Mhz GPS chip SIRF3 chip GPS sensitivity -159dBm GPS accuracy Time To First Fix Cold status 45s Warm status 35s Hot status 1s Car charger 12—24V input 5V... -
Page 6: Usage
GPS unit. This tracker uses built-in Li-ion battery technology, and a fully charged battery can power the TK102-NANO from 16 hours up to 30 days depending on usage and standby mode. After the first use, the battery should be charged for 2-4 hours. -
Page 7: Changing Your Password
Once GSM and GPS connection is established, the led light will start flashing less frequently. While reading the set-up commands, you will notice that some words are seperated by + or space. + means two words should be written without a space, as one word. Space means a space should be left between two words. -
Page 8: Authorization
+447776665544 You have to enter your phone number in +44 international format for TK102-NANO to be able to recognize your phone number. When entering your phone number in international format, do not forget to drop the first 0 before your number. For instance, 07771112233 should be entered as follows ;... -
Page 9: Interval Tracking
5.7 Interval tracking TK102-NANO can send automatic location reports at set intervals. If SMS mode is active, re- ports will be sent as SMS Text messages. If GPRS tracking mode is active, updates will be uploaded to the online tracking server. - Page 10 To activate monitor mode: Command: monitor+password Response: monitor ok! e.g. monitor123456 Now the TK102-NANO will answer your calls and you will be able to listen through the built- in high sensitivity microphone. To switch back to tracker mode Command: tracker+password...
-
Page 11: Data Logging
Logging at preset intervals: Command: save030s005n+password Response: save ok e.g. save030s005n123456 Once set, TK102-NANO will store the lat, long locations every 30 seconds for 5 times. (S: second, m: minute; h: hour). Continuous logging: Command: save030s***n+ password Response: save ok e.g. -
Page 12: Shock Sensor Alarm
Shock sensor alarm is deactivated by default. To activate: Command: shock+password Response: Shock is activated! e.g. shock123456 Now when TK102-NANO detects vibration, it will send SMS “Sensor alarm+location” to authorized numbers. To cancel shock sensor alarm: Command: noshock+password e.g. noshock123456 Shock sensor sensitivity configuration: The shock sensor module has three different sensitivity settings;... -
Page 13: Geo-Fence
This feature allows you to create safety zones. When the TK102-NANO enters or leaves this zone, it will send geo-fence alarm warnings to authorized numbers. To be able to configure geo-fence TK102-NANO has to stay stationary for 5 minutes. After 5 minutes proceed as follows;... -
Page 14: Over Speed Alarm
5.19 Low battery alarm Low battery alert helps users to know when the battery of TK102-NANO is low. It sends 3 notifications to authorized numbers; at %10 , at %5 and just before it's completely flat. Low battery alert is activated by default. To activate;... -
Page 15: Gps Blind Spot Alarm
5.22. Standby modes Timed standby after 5 minutes When activated, after having no activity (call or sms commands) for 5 minutes, TK102-NANO will change to standard standby mode; GPS module and led light will be OFF, GSM module (phone line) will still be ON. It will wake up and turn the GPS module ON only if you call it to request position or send an SMS command.. - Page 16 GPS module and the led light will shut off, GSM module will still be ON. As the GSM module will be ON, you will still be able to communicate with the TK102-NANO. Vibration, movement, calling the tracker or sending an SMS message can wake it back up. To activate;...
- Page 17 = days . Maximum schedule setting is 30 days. Please check Schedule work standby mode setting examples below; schedule123456 30m -- this will set the TK102-NANO to stay in standby and report its location for 5 minutes every 30 minutes.
-
Page 18: Sim Card Balance Check
5.24 Sim Card balance check Using this function tracker you can instruct the TK102-NANO to send an SMS message to a specific phone number. For instance, to send a text message to your Sim card network provider to check the credit balance and it will forward the received content to the authorized number. To check Sim card balance proceed as follows;... -
Page 19: Tcp/Udp Switch
Command: gprs+password,1,1 UDP without keepalive data 5.29 Reset This command will restart/reboot GSM & GPS modules of TK102-NANO. Please note that this is only a hardware reboot, it will not restore TK102-NANO's settings to factory defaults. Command: reset+password Response: reset ok e.g. -
Page 20: Pc Software Tracking
5.30 PC Software Tracking The free PC Software supplied with your TK102-NANO can be used for both GPRS tracking and downloading GPS Logs. Please note that if you wish to use GPRS tracking mode with this Software, you will need to open ports from your router and firewall for the tracker to be able to communicate with your PC.Log-in details for the software are: User ID: admin... -
Page 21: Gprs Economy Mode
94.229.67.57 10200 If you are going to use Rewire security's UK based server www.gpslive.co.uk, use the IP address and port above. 94.229.67.57 is the IP address and 10200 is the port of the server. 5.33 GPRS economy mode With the GPRS economy mode, after being stationary for 5 minutes, 102-NANO can close the internet connection to save battery power and internet data usage.