Table of Contents
Advertisement
The Program Screen
The main program screen displays graphs of the current
positions of each of the six channels corresponding to the six
potentiometers on the KEAD6.
Switching Selected Device
If two KEAD6 units with properly assigned Device ID jumpers (see
page 2, section "Device ID Jumper") are both connected to the
PC, then the KEAD6.EXE program must be set to which device
to monitor. In the lower right corner of the main screen there
are two checkboxes which are used to switch between Device
1 (left box) and Device 2 (right box). To change which device
is selected, click on the corresponding checkbox. An alternate
method is to select the Device ID under the Options menu.
If using a single KEAD6, the selection will be made automatically
by the program.
5
Advertisement
Table of Contents
