Table of Contents
Advertisement
Step Mode
When programmed to send keystrokes, channels can be placed
into a step mode where the channel becomes sectioned into a
number of equal parts in which each section can be assigned
a different keystroke. To place a channel into step mode, fi rst
open the settings window for the channel. Make sure that the
keyboard enabled checkbox is checked. Change "Number of
steps" to 2, 4, 8, 16, or 32, as shown below. The keystrokes
these steps produce can be assigned by clicking on a section
of the graph and selecting a key representation as described in
the "Assigning Keystrokes" section found later in this manual.
When a channel has been set to step mode, the programmed
keystroke for that position is sent when the potentiometer value
crosses into that particular step from either direction.
13
Advertisement
Table of Contents
