Table of Contents
Advertisement
not be sent out for another 5 seconds afterwards.
The time
between the sending of each keystroke can be set between 0.1
seconds and 10.0 seconds. When set to disabled, no periodic
keystrokes are produced.
Joystick Enabled Checkbox:
Checking this box enables the joystick
section and activates programming of
joystick axis. If this box is unchecked
the joystick is disabled for this channel. The joystick should be
disabled for a given channel if it is not to emulate an axis.
Axis: Each channel can be set to one
of several different axes or controls as
listed below.
• X, Y or Z axis.
• Rx, Ry or Rz axis.
• Slider.
• Dial.
• Wheel.
• Vx, Vy or Vz axis.
• Vbrx, Vbry or Vbrz.
• Vno.
To make a selection, open the drop down list by clicking on the
down arrow next to the current selection and click on the new
choice of axis or control. A particular axis from the list may
only be used in one channel and will not appear in the list if it is
used in another channel. For example if in channel 1 settings
the joystick is enabled and the X axis is selected then the X axis
selection will not be available in the axis
drop down list in the other channels.
When a joystick axis or control is chosen, the
selection will be displayed in yellow text in
the middle of the channel settings window.
ow.
For example if the X axis is selected the
selected th
the
following will be displayed.
layed.
12
Advertisement
Table of Contents
