Interfacing to the KEAD6
The three-position screw terminal blocks on the KEAD6 are
used to connect potentiometers to the unit. The potentiometers
used with each KEAD6 input can range in value from 500 up
to 1M . Potentiometers are connected to the +5V, Wiper input,
and Ground as shown below.
The four position header on the KEAD6 provides three inputs
and a logic ground signal. To activate an input, short it to the
provided logic ground through a switch. The activation of the
switch will create a joystick button press on the computer.
Ground
Wiper
+5V
Three Joystick Buttons
3
Button 3
Button 2
Button 1
Gnd