KE18 Keycode Lookup Tables Accessories Thank you for purchasing the HAGSTROM ELECTRONICS, INC. KE18. This product is confi gurable in a variety of ways to meet your specifi c requirements. Please take a few minutes to read this manual before using your KE18.
6). The 40 pin dual row header serves as the connection point to each of the I/O pins on the KE18. This header accepts a variety of connectors, including the plug on many off the shelf keypads. This header also provides a convenient place for attachment of individual switches.
Confi guring the KE18 Jumpers The KE18 is designed to be easy to use. There are 3 jumpers located on the board which allow for selection of various modes. These jumpers must be set before using the product. Jumper 1 This jumper selects the repeat function of the inputs on the KE18’s...
Page 5
Jumper 3 Use this jumper to select the type of PC with which the KE18 will be used. With this jumper removed (the most commonly used setting), the KE18 operates in the PS/2 “AT” mode, compatible with Pentium and X86 computers.
Interfacing to the KE18 I/O Header Interface of the KE18 to switches and keypads is accomplished by connection to the 40 pin dual row I/O header. Each of the pins of the header is connected in parallel with the adjacent pin. This provides 20 individual interface signals, with both the end pins being logic Ground.
The DIN connector marked “KBD” is for using an external keyboard with the KE18. Plug the keyboard into this port to use it in addition to the KE18. Use of the keyboard is optional; a keyboard does not need to be plugged into this port for the KE18 to operate.
KE18 Keycode Lookup Tables The following tables list the keycodes that are sent to the computer by the KE18 in response to activation of an input. KE18 Keycode Lookup Table (18 Input Mode) KE18 Header Input Pins C D E...
Accessories KE-MM6-mini 6 pin miniDIN Male/Male 6 foot cable. Connects KE18 with 6 pin miniDIN connectors to computer. KE-MM6 5 pin DIN Male/Male 6 foot cable. Connects KE18 with 5 pin DIN connectors to computer.
Page 10
Sold as a set of two; 20 total wires. Custom lengths available (up to 10 feet); call for pricing. MTA100-10-12 KE18 Header IOX36-KE18 Screw terminal block can be used to easily connect your device to the KE18. 40 pin IDE ribbon cable included.
Page 11
Depending on the state in which you live, you may have additional rights. Great care has been taken during the assembly, testing, and burn-in of your KE18 to ensure its performance. If you have any questions, please send us an email or give us a call. Support is available Monday through Friday, 8:00 am to 5:00 pm (EST).