Siemens SIMATIC S5-100U System Manual page 475

S5-100U
Using a limit switch on the digital inputs, IP 267 can monitor the limits of a traversing range and stop
the traversing movement when the permissible range limit is exceeded.
The activated input "external stop" causes a calculated decelerating of the traversing movement.
An emergency limit switch can be installed at input "IS" (pulse inhibit). When this switch responds,
the pulse output is interrupted immediately.
For a reference point approach operation, an additional switch can be connected at input REF that
lies within the traversing zone. The reference point approach operation is also possible without this
switch.
Status LEDs provide you with the following information:
• The IP 267 is configured
• Pulse outputs during a positioning operation
• Interruption of the positioning operation
There are four operating modes:
• STOP
• START FORWARDS
• START BACKWARDS
• NEUTRAL
Installation
1. Plug the IP 267 into a bus unit like any other I/O module (see chapter 3).
2. Insert the IP 267 module only into slots 0 to 7.
3. Connect the external switches to the DIs of the IP 267 via the terminal block.
4. Connect the stepper motor's power section to the 9-pin subminiature D female connector.
Addressing
The IP 267 is addressed like an analog module.
EWA 4NEB 812 6120-02b
RDY
ACT
ABT
Function Modules
15-61