Table of Contents
Advertisement
Setting the Fireplace into the Framing
The left and right nailing tabs were designed as a means
to ensure the fireplace is mounted flush with the framing
materials. See Figures 4.2-4.3.
1. Bend out all nailing tabs. The ODMEZG-36 has 6 nail-
ing tabs. 2 on the indoor side in the middle of the unit.
4 on the outdoor side (shipped in the manual pack).
Hand bend these along the perforated bend line and
attached to the sides of the outdoor face. These are
adjustable to accommodate various finishing meth-
ods. Attach each of the outdoor nailing flanges with 2
screws.
2. Screw each nailing tab to the adjoining framing mate-
rial. Ensure that the 1" air space clearance is main-
tained on the side of the fireplace. See Figures 3.2-
3.4 for framing and clearance details.
1 IN. STANDOFF
NAILING
TAB
Figure 4.2 Nailing Tabs
Interior Side
• Optional: Secure the appliance to the floor by inserting
two screws through the pilot holes at the bottom of the
appliance.
14
NAILING
TAB
SHIPPING
FLANGE
Figure 4.3 Nailing Tabs
Exterior/Outdoor Side
Outdoor Lifestyles • ODMEZG-36 Installation Manual • 4601-901 Rev. B • 10/17
B. Installing Non-Combustible Facing Material
WARNING! Risk of Fire!
• Follow these instructions exactly.
• Facing materials must be installed properly to prevent
fire.
• No materials may be substituted without authorization
by Hearth & Home Technologies.
• Non-Combustible facing material needs to be at least 6"
high and the full width of the unit.
• Attach non-combustible facing material to the framing
members with regular sheetrock screws.
• Use a wet or dry towel or soft brush to remove dust or
dirt from facing material.
• See Section 10 for finishing materials guidelines.
Figure 4.4 Install Non-Combustible Facing Material
Advertisement
Table of Contents
