C. Light Installation - Outdoor Lifestyles ODMEZG-36 Installation Manual

C. Light Installation

1. Remove the front floor screen frame by unfastening
the eight (8) screws securing the front and sides.
2. Install the six (6) halogen light bulbs provided. Do not
touch light bulbs directly with fingers.
3. Replace the front floor screen frame. Be sure wires do
not get pinched below the light channel.
4. Repeat procedure for lights on opposite side.
Floor Screen
Frame
Pilot is
Located
in Center
Halogen Light
Bulbs
Figure 10.5 - Install Light Bulbs
FP2434
replace light bulbs
46
Screws
FP2435
Outdoor Lifestyles • ODMEZG-36 Installation Manual • 4601-901 Rev. B • 10/17
D. Glass Only Placement
NOTE: Three (3) bags of glass are supplied with the
fireplaces. It is not necessary to use the entire 3rd bag
of glass provided. Too much glass can cut off the proper
amount of air the burner needs to burn clean. This may
cause sooting.
1. Spread glass evenly in one layer over the entire floor
and burner. It is important to not have the glass too
heavy on ported area (single layer only).
2. Turn burner on and adjust glass over ported areas to
achieve a clean flame.
3. Replace glass frame and access door in reverse order
of removal.
Firebox
Burner
Perimeter
Surface
Example of Stone Placement
Figure 10.6 - Stone and Glass Placement
FP2434
stone placement
D. Stone Placement (Optional)
NOTE: Up to three (3) packs of stones may be used.
Stones should be placed around, but NEVER direcly on
the burner or pilot area, as sooting may occur. Arrange the
stones to suit your style.
Rear
Vent