Table of Contents
Advertisement
The software should start with only "LMH0303" or "LMH0307" in the "Devices" pull down menu. If there are more
devices then the software is most likely in demo mode. When the ALP is operating in demo mode there is a
"(Demo Mode)" indication in the lower left of the application status bar as shown in Figure 13.
Figure 13. Analog LaunchPAD in Demo Mode
Disable the demo mode by selecting the "Preferences" pull down menu and un-checking "Enable Demo Mode".
Figure 14. Analog LaunchPAD Preferences Menu
After demo mode is disabled, the ALP software will poll the ALP hardware. The ALP software will update and have
only "LMH0303" or "LMH0307" under the "Devices" pull down menu.
SD303/SD307 EVK User Guide
17 of 27
Rev 1.2
© 2010, National Semiconductor Corp.
Advertisement
Table of Contents
