FASTRON. VISION Series Programming Manual page 6

Programming the Controller
Adding Product and Pre-alarm
Names—3228
Programming a Custom Product and
Pre-alarm Name
Press and hold the "P" for 3 seconds.
Product Cnt will be displayed. Press the down
arrow.
Programming will be displayed, then press the "P"
key.
ENTER CODE will be displayed.
From ENTER CODE type in 3228 then press the "P"
key.
Display will show System. Press the down arrow
key until either ProdName Lib or Alarm Lib is
displayed.
Press the "P" key and a flashing dash will be
displayed.
Press the SCAN key and use the number keys to
spell the new word using the right arrow key to
go to the position of the word. Once the word is
spelled press the "P" key and Save Library ADD
will be displayed.
If you press the "P" key again the word you
spelled will be saved. If you don't want the word
or need to modify it, press the left or right arrow
key to CANCEL or MODIFY and press the "P" .
NOTE: To delete the word and start over press
the TOGGLE/CLEAR key.
To Exit Library Mode
Either ProdName Lib or the Alarm Lib will be
displayed. Press the arrow up or down key until
the display reads Exit. Press the "P" key.
This document contains confidential information. The dissemination, publication, copying, or duplication of this document or the software described herein without prior written authorization is strictly prohibited.
6
Vision Vertical Oven Controller
www.fastinc.com 1-800-243-9271
229-51414C © 2008-2010 FAST