Bauer MSXH Operating Manual page 38

LUBRICATION AND MAINTENANCE SCHEDULE
Always turn power off when changing oil or lubricating, and secure the mixer from unintentional switching on.
Interval after 750 operating hours
First oil change: unscrew filling
bolt too for complete draining.
Tightening torque for filling and
OIL CHANGE /
drain bolts:
OIL CHECK
M16x1.5 = 34 NM
Rope winch
Tighten bolts and nuts
Electric cable
and general
overhauling
Tighten hose clips of
Level control
connections
probes
Oil quality: SAE 90 gear oil; quantity: 6.5 l
Shell Spirax S2 G 80W-90
Attention: An overpressure may be created inside the oil casing.
OIL CHANGE
1. Unscrew bolts 1, 2 and 3
2. Drain oil
3. Put back bolts 1 and 3
4. Fill in oil up to level checking screw 2 according to instructions.
5.
Put back level checking screw 2.
2
CAUTION !
Operating Manual for BAUER Submersible Mixer/ Version I-2013
3
1
Wrap thread of bolts and screws with teflon tape or muffle it with thread sealant
before screwing to ensure absolute leak tightness.
1
every six months
Remove level checking screw
and check oil level and quality.
(The colour of the oil must not
be white!)
Tightening torque for filling and
drain bolts:
M16x1.5 = 34 NM
Clean, lubricate and check
wear
Check wear, twisting and
possible rupture. Tighten bolts
and nuts.
Clean and check hose
connections of probes
after 2000 houres
Change oil
Unscrew filling bolt to allow
complete emptying at
draining hole.
Tightening torque for filling
and drain bolts:
M16x1.5 = 34 NM
38