Mounting Of Mixer - Bauer MSXH Operating Manual

4.3 Mounting of mixer

Put the rope over the rope pulleys and attach its thimble at the mixer console. Use the winch to bring the mixer
into a position under the guide tube bracket and secure the guide console at the bottom, behind the guide tube.
By changing the position of the mixer holder the mixer can be brought into a horizontal position – or it may be
slightly inclined (+/-15°).
Lateral swivelling is limited by the two screw bolts affixed to the backing plate.
4.4 Mounting of rope
Wire rope clips
thimble
Number of wire rope clips needed for rope diameter of 8 mm: 3
Where to fix the rope clips:
First rope clip: Standard thimble: directly at the thimble
Round thimble: twice the diameter of the thimble away from thimble
Second and third wire rope clip:
6 times the rope diameter from clip to clip (i.e. for rope diameter of 8 mm spacing between
clips: about 48 mm)
Tighten rope clips after putting rope under traction.
CAUTION!
max 8d max 8d
max 8d
min 6d
Operating Manual for BAUER Submersible Mixer/ Version I-2013
6d 6d
Make sure to mount the rope clamps correctly.
The bracket of the clip must always be put onto the end of the rope which is not
under traction.
max 8d
richtig
Gright fit
correct
min 6d
Rope end secured against
ragging
Gwrong fit
richtig
correct
14