Cabinet Air Conditioning - Siemens SINAMICS G130 Operating Instructions Manual

Cabinet air conditioning

5.1 General
The minimum dimensions listed below for ventilation clearances must be observed. No other
components or cables must be located in these areas.
NOTICE
Avoid the reduction of service life
If the guidelines for installing SINAMICS G130 equipment are not observed, this can
significantly reduce the service life of the components and result in premature component
failure.
You must take into account the following specifications when using SINAMICS G130:
● Ventilation clearance
● Wiring and cabling
● Air guidance
Table 5- 1 Ventilation clearances for the components
Component
Power Module
Power Module
Power Module
The clearances refer to the area around the ventilation slots on the front cover.
1)
Note
Notes on the dimensions
The dimensions refer to the outer edges of the devices.
A dimension drawing is available in the Operating Instructions.
Cabinet design and EMC
Operating Instructions, 03/2013, A5E00427629A
Frame size Clearance (front)
FX
GX
HX, JX
Clearance (above)
[mm]
40
1)
50
1)
40
1)
Clearance (below)
[mm]
250
250
250
5
[mm]
150
150
150
21